Thermo Scientific Orion Star A111, Справочное руководство

Страница: 12 / 30

8 Thermo Scientific Orion Star A111 Benchtop and Star A121 Portable pH Meters
Meter Setup
Setup
Menu
Level Secondary
Display Primary Display Description Information
Main 1.0 CONF Configuration Select measurement resolution and buffer set
Submenu RES 0.1, 0.01 Measurement
Resolution 0.01 is the default.
Submenu CAL AUTO, MAN To select AUTO or
MANUAL calibration Note: If CAL AUTO is selected, then go to BUF submenu.
Submenu BUF USA, DIN Buffer Set for
Automatic pH Buffer
Recognition USA buffers are: 1.68, 4.01, 7.00, 10.01 & 12.46. DIN
buffers are 1.68, 4.01, 6.86 & 9.18. USA buffers are the
default.
Main 2.0 GEN General Meter Setup Automatic meter shut-off
Submenu AUTO ON, OFF Automatic Meter
Shut-Off To save battery life, the meter will turn off after 15
minutes without any key presses. On is the default
setting.
Main 3.0 TEMP Temperature Settings Select temperature units and the temperature used for
manual temperature compensation
Submenu UNIT DEGC, DEGF Temperature Unit The default setting is for temperature readout to be
displayed in °C.
Submenu DEGC or
DEGF
-5.0 to 105.0 Manual Temperature
Compensation Value This value is used when there is no ATC probe
connected, and can be set with the meter’s temperature
ranges. The temperature unit for this value will match
the temperature unit already selected. The default
setting is 25.0°C.
Submenu READ AUTO, CONT AUTO is for AUTO-
READ. CONT is for
continuous read. In AUTO-READ mode, the meter will display the
measurement as it stabilizes and lock and hold the
measurement when it is stable. Press
to take a
new measurement.
In Continuous read mode, the meter will continuously
measure and update the display. The unit of measure will
flash. When the reading has been stable, “READY” will
stop flashing. The default setting is AUTO-READ.
Main 5.0 LOG Datalog Clear
Submenu DATA ON, OFF To enable data storage The default is off.
Submenu DEL NO, LAST, ALL Clears any stored
readings in the
datalog. The default is no.
"NO" does not delete any readings.
"LAST" deletes only the last reading.
"ALL" deletes all of the logged data.
Main 6.0 CAL Calibration Data Allows for review and clearing of saved data.
Submenu SLP.1,
SLP.2,
SLP.A
80.0 to 120.0 Slope Information This is the slope data from the last calibration.
SLP.2 and SLP.A (average slope) will only show
if 3 points are calibrated.
Press and to scroll between them.