Thermo Scientific IMP 180, Руководство пользователя, Страница: 77 / 118

Handling and Control
Settings
Thermo Scientific Heratherm IMP 7-23
Mode after End (of Program)
Additionally this command allows for enabling a second prompt (also deactivated when the
refrigerated incubator is shipped from the factory) that appears when the user launches a
program and asks for the mode of operation the should continue to run upon completion of
the program (see
“Launching a Program” on page 7-26 ):
• Off: This option turns the device off when the program ends. It does not prompt the user
to confirm.
• On: When the user launches a program, this option prompts whether the should be
turned off or continue to run in hold mode with the latest settings until the user
acknowledges the end of the program.
An active weekly timer will be suspended until the
Program End
message is acknowledged.
Upon resuming the timer, the refrigerated incubator will seek to establish the set value that
was in place before the program was started.
In the subsequent selection screen, enable the prompt
(deactivated in “as shipped” state) by using to
move the selection from
Off
to
On
state.
To deactivate the prompt, switch back from
On
to
Off
state using or and confirm the selection with
.
When you choose
Off
, the is switched off after just one
program cycle. You may change this default behavior
by changing the “Mode after End (of Program)”
preference explained in the next section.
The display returns to its default mode.
The
Settings
icon in the menu bar will go out.
Table 7-25 Activating / Deactivating the Program Cycle Prompt
2010-04-09 13:43
PM
Program
Loops
On
2010-04-09 13:43
PM
Program
Loops
Off
Table 7-26 Changing the Mode after End
Press to activate the menu bar, then use or
to select the
Settings
icon and press to
confirm.
The
Error
menu item from the
Settings
submenu
appears in the multifunctional display pane.
2010-04-06 1:33
PM
Settings
Error