Thermo Scientific Dionex UltiMate 3000 Series, Руководство по эксплуатации

Страница: 114 / 270

UltiMate 3000 Series:
NCS-3500RS and NCP-3200RS
Page 106 Operating Instructions
5.4.2.3.4 Configuration Menu
The Configuration menu provides information about the configuration of the column
compartment and allows you to make the required settings or change the settings.
To … Select …
Set the display and function key parameters:
Brightness —sets the screen brightness. (The input is in percent.)
Contrast —sets the screen contrast. (The input is in percent.)
Key sound
—sets whether a beep sounds when you select a function key.
Key autorepeat —sets whether the keystroke is automatically repeated when
you remain on the key for a longer period, for example, to change a value
quickly.
Display & Soft Keys
Specify which valve is installed in the left and/or right position. Left Valve Config
Right Valve Config
Determine whether leak detection is performed and how you are alerted in
case of an alarm. Select the sensor and set the sensitivity:
Low , Standard , or High —turns leak detection on and sets the sensitivity
with which the sensors respond to excessive gas or humidity. When a sensor
is activated, a message appears on the pump display and a beep alerts you
(when set under
Leak Alarm Mode
).
Off —turns leak detection off.
Gas Leak Mode
Humidity Leak Mode
Determine whether a beep alerts you when the gas and/or humidity sensor is
activated, in addition to the message on the pump display (audible = yes,
silent = no).
Leak Alarm Mode
Move the actuator for the column switching valve into the correct position for
valve installation if necessary. For details, see section 4.6.1 (
→
page 78).
Catch Left Valve Head
Catch Right Valve Head
To restore the factory settings for the column compartment. In the Reset to
factory defaults? dialog box, select OK to confirm the restore the factory
settings or select Cancel to keep your settings.
Reset to Factory
Defaults