Thermo King T-1080S, Руководство по обслуживанию

Страница: 51 / 191

Operating Instructions for Premium HMI Control Panel
50
Figure 51: Language Menu
When the unit is ready to run the Standard Display
appears.
Figure 52: Standard Display
Pressing the OFF key stops unit operation. The
unit shuts down immediately and the display
briefly shows the power down message.
Figure 53: Power Down Message
The display briefly shows OFF and then goes
blank. To start the unit again, press the ON key.
Figure 54: Off Display
The Standard Display
The Standard Display is the default display that
appears if no other display function is selected.
The Standard Display shows the box temperature
and setpoint. The box temperature is that
measured by the controlling sensor, usually the
return air sensor. The box temperature in Figure
55 is 35.8 F with a 35 F setpoint.
Figure 55: Standard Display
The CYCLE-SENTRY Icon in the upper right
corner of the display shows that the unit is
operating in CYCLE-SENTRY Mode. If the
CYCLE-SENTRY Icon is not present, the unit is
operating in Continuous Mode.
The down-pointing arrow indicates that the unit is
cooling. If the unit was heating the arrow would
be pointing upward.
Pressing the left soft key allows the user to change
the SETPOINT, and pressing the right soft key
accesses the MAIN MENU. The other two soft
keys access the GAUGES menu and the
SENSORS menu.
Changing the Setpoint
From the Standard Display, press the SETPOINT
soft key.
Figure 56: SETPOINT Key
The setpoint display appears as shown in Figure
57.
Figure 57: Setpoint Display
The "-" and "+" soft keys are used to increase or
decrease the setpoint until the desire setpoint is
shown. In Figure 58 the setpoint has been
changed to 40 F using the "+" key.