Thermo King SLXe SPECTRUM, Руководство пользователя

Страница: 12 / 282

10
UNIT DESCRIPTION
CONTROL KEYS
SWITCHING “ON” THE UNIT
1. On/Off Master Isolator Switch must be ON.
2. Press the I/ON Microprocessor key for 1
second.
3. Unit is switched “on”.
ON/OFF MASTER ISOLATOR SWITCH
On/Off Master Isolator Switch is located above
engine inside the unit. The switch is normally
left in On position.
On/Off Master Isolator Switch
See “Drivers Guide to Simple operation” for
more information about SR-3 controller.
Contact your Dealer for access to this
document.
CYCLE-SENTRY START/STOP
CONTROLS
The CYCLE-SENTRY system automatically
starts up the unit when heating or cooling is
required and shuts it off when the cargo box
temperature reaches the controller setpoint.
The CYCLE-SENTRY system also maintains
engine temperature by restarting the unit if the
engine block temperature drops below -1°C. It
runs until the controller demand is satisfied and
the engine block temperature reaches 32°C.
CYCLE-SENTRY is designed for use only
with products which do not require tight
temperature control or continuous airflow, such
as all deep frozen products and non-perishable
non-frozen products.
The start/stop nature of CYCLE-SENTRY does
not satisfy the temperature control or airflow
requirements for perishable or temperature
sensitive products. Thermo King therefore does
NOT recommend the use of CYCLE-SENTRY
control for these products.
DEFROST
As the unit is operated to cool the trailer, frost
will gradually build up on the evaporator coils.
Periodically this frost must be melted to
prevent loss of cooling and airflow.
MODULATION
Systems equipped with modulation can provide
precise temperature control of fresh products.
This can reduce product dehydration, increase
product shelf life and protect fresh products
from freeze damage.
On Key
Turns the unit on.
(hold button 1 second)
Off Key
Turns the unit off.
Defrost Key Initiates a Manual
Defrost
Mode Key Switches the unit
between the CYCLE-SENTRY
and Continuous Run modes.
Soft Keys
The four soft keys are
multi-purpose keys. Their
function changes depending on
the operation being performed. If
a soft key is active, it’s function
will be shown in the display
directly above the key.