Thermo King Precedent S-750i, Руководство по установке

Страница: 32 / 48

32
TK 57073-2-IM-EN
Installing UFLS Harness – Trailer Applications
D DA AN NG GE ER R
F Fiirre e H Ha azza arrd d!!
D Do o n no ott rro ou utte e e elle eccttrriicca all h ha arrn ne essss tto og ge etth he err w wiitth h ffu ue ell lliin ne ess a ass tth hiiss cco ou ulld d cca au usse e a a ffiirre e rre essu ullttiin ng g iin n d de ea atth h o orr sse erriio ou uss
iin njju urry y..
IIm mp po orrtta an ntt:: All electrical connections from UFLS harness to UFLS must be made with supplied crimp and solder style
connectors with separate heat shrink tubing. DO NOT burn heat shrink. If heat shrink is burnt, charred, or
has bubbles from overheating, the wire connections must be removed and redone correctly.
N No otte e:: Refer to illustration on following page.
1. Attach interconnect harness 3–pin connector to mating capped off connector ((F FU UE EL L--0 01 1,, F FU UE EL LN N--0 01 1 a an nd d F FU UE EL LP P--0 01 1))
located near unit controller.
2. Route interconnect harness to fuel tank using trailer’s harness conduit or chase to avoid interference with fifth wheel
plate area.
3. Splice interconnect harness wires to the UFLS wires by following steps a-d below.
a. Slide supplied heat shrink tubing onto each wire and position them away from joint.
b. Connect each wire with wire connector and crimp securely.
c. Solder wires to wire connectors with a soldering gun.
d. Slide heat shrink tubing over each wire connector and applying heat with a heat gun.
4. Secure harness with clamps as needed.
IIm mp po orrtta an ntt:: This is a “Solid State” fuel level sensor and the S-750i Controller must be programmed accordingly to
enable the fuel level feature.
RCS1934
3
Connections at
Sensor
BLACK to BLACK
WHITE to YELLOW
GREEN to RED
1
2
4