THERMEx Sirius PM 24, Инструкция по установке и эксплуатации

Страница: 5 / 20

2
i. Arising from other accessories and ancillary products used with the appliance,
k. Manipula on of data plate and warranty cer ficate,
j. Arising from freezing
h. Arising from the failure of observing the periodic maintenances specified in the instruc ons to
be done in me by the authorized service agencies,
l. Using the appliance in a cold water supply network out of the condi ons set in this instruc on
manual,
WARNING: When the boiler is first switched on it starts with the AP mode and the boiler runs the
fan with high speed for 120 s. to purge the combus on chamber. If this mode is not required push
the reset bu on to switch normal start.
4. SWITCHING ON THE BOILER
Before star ng the boiler ensure electric, gas and water connec ons are properly made and the
appliance is supplied with correct power as stated in the data plate.
a. Open power supply connec on.
b. Turn gas cock to open posi on.
The warranty does not apply to above specified failures, and repair of such failures is subject to a
fee.
e. Start the boiler by adjus ng to your desired temperature through temperature adjustment
bu ons
WARNING: When the boiler is first started the boiler may show igni on failures and go into block
several mes ll the air in the gas supply line is evacuated. In that case push bu on for 5
seconds to restart the boiler.
c. Push the ON bu on ( ).
WARNING: In summer mode the boiler does not start unless a hot water tap is opened.
d. Select Summer/Winter ( ) mode. Figure 1