THERMEx Rigel PM 24, Инструкция по установке и эксплуатации

Страница: 10 / 20

7
The followings must be observed when making flue connec on:
b. Building aisles,
d. On the chimney walls
11. CONNECTING THE FLUE
When connec ng the flue, the flue gas accessories supplied by the manufactured must be used.
When selec ng the loca on of the boiler the posi on of flue gas connec on and flue terminal should
be considered. For flue connec on the requirements set forth by the local authori es and gas
distribu ng company must be observed.
c. Light-wells,
Flue connec on must not be made to:
b. Minimum ver cal distance above the ground should be 0,3 m and in places where there is an impact
risk the flue terminal must be covered with a wire net.
a. Building stairwells,
e. Balconies
f. Elevator sha s.
c. When the flue terminal is extended off the wall it must extend minimum 50 mm outside the wall.
d. Horizontally connected flue connec ons must be installed with 5% upward slope.
a. Flue terminal ver cal distance to eaves and roof coverings should be minimum 1,5 m from the top
and should also extend further from such eaves and roof coverings.
e. Where the appliance is installed to penthouses flue terminal should be minimum 40 cm above the
roof. In such cases the roof must be insulated with non-combus ble material.
f. Maximum length of the flue connec on is 9 m. Maximum length is shortened by 1 meter for each
addi onal 90° elbow and 0,5 meter for each addi onal 45° elbow.
g. Roof ghtness must be fully ensured with ver cal flue applica ons. In case where ghtness cannot
be ensured any failure or damage which may arise is out of warranty claim.
Figura 7
8