THERMASOL.COM
I
800.776.0711
Read warnings on page 2. For illustrative purposes only. Consult with qualified professional for steam room construction details.
4
Signature Series Control Installation Instructions
Connect the data cable to steam generator connector.
(The other end of the cable runs to the back of the control in
the the shower location or to the SWM-2 or PDM if present.
Route the data cable (included with
generator) through the finished wall
to the back side of the control.
The other end of the cable runs to
the steam generator location or if
present to SWM-2 or PDM.
NOTE: It is recommended to run
the cable through electrical conduit.
DO NOT pinch, nail, staple, wedge, or
bind the data cable.
DO NOT wrap the data cable around
steam line or route it in a manner so
that the hot steam line could melt
the cable.
Any damage to the control cable
will result in the control not working
properly.
Carefully connect the data cable to
the generator and control BEFORE
turning power on to the generator.
"ON"
Turn Clockwise
"OFF" Turn
Counter Clockwise
• Do not staple, strain or damage data cable
• Align pins to receptacle visually before tightening
• Do not force plug
• Hand tighten only
Connector
Detail
Back of
control
or side of
generator
Back of Control
Side of generator
Contact pins
Contact pins Cable ends
Back of
control
or side of
generator
4
Control Installation and Data Cable Connection
81173_NC 3/16
