Fig. 1
Fig. 2
Fig. 3
M
ATTRESS
S
NAP
K
IT
Instructions
©2009 Casc
ade Designs, Inc.
4000 First Avenue South, Seattle, WA 98
134 U.S.A
1-206-5
05-9500 | 1-800-5
31-95
31 | www
.thermarest.com
Made in Seattle, U.S.A. |
A
Printed on recycled paper | P
.N. 33-1
71
Fabriqué à Seattle, États-Unis |
A
Imprimé sur du papier recyclé
MATTRESS SNAP KIT
The Mattress Snap Kit allows you to attach Therm-a-Rest comforters
and blankets directly to any Therm-a-Rest mattress, creating a lightweight
sleep system.
Contents:
(4) Male Snap Tabs
(4) Female snap Tabs
Instructions for applying Snaps to any
Therm-a-Rest
®
Mattress
1.
On a flat surface, lay out Therm-a-Rest blanket or comforter with bottom
side facing up, and place mattress on top.
(see fig. 1)
IMPORTANT! Make sure male snap tabs mate with female snaps on
your blanket/comforter and vice versa.
2.
Begin by peeling off backing and applying two snap tabs completely flat
on the foot end of the mattress where blanket/comforter snaps line-up.
Note that the blanket/comforter should wrap around the bottom of the
mattress.
(see fig. 2)
Firmly press on tabs.
3.
Gently snap blanket/comforter to mattress, being careful not to pull on
newly affixed snaps.
4.
Working up the sides, continue to the next snap and place a tab on the
mattress seam where it lines up with the blanket/comforter snaps. Be sure
that the snap side of the tab is on the bottom side of mattress. The metal
snap should be close to the edge seam and excess tab extends past the
mattress edge.
(see fig. 3)
5.
Press down the tab firmly with fingers and fold over excess tab to top side.
6.
Continue working up the sides of the mattress, repeating the process for
remaining tabs.
7.
To remove blanket/comforter, firmly hold snap tabs in place on each side
of snap while gently releasing the two foot-end snaps. (This is not neces-
sary once adhesive has cured.)
8.
For best results, allow 24 hours for the adhesive to cure.
M
ATTRESS
S
NAP
K
IT
Instructions
M
ATTRESS
S
NAP
K
IT
手順
Mattress Snap Kit Inst_09_r4.indd 1
12/4/08 2:54:49 PM