Instrument Configuration
You can personalize your Thermapen ONE by changing several factory default settings
including:
Temperature display from °F to °C
Display resolution from 1° to 1.0°
Screen Rotation
Auto-Off/Sleep Mode
To change any of these settings, loosen the battery
cover screw using a Phillips screwdriver and remove
the battery cover. Open the probe to turn the unit
on. Thermapen ONE has two small buttons inside
the battery compartment: MENU, which is used to
enter, save settings, and exit the menu; and SET,
which is used to select desired settings.Settings are
saved once ‘END’ is displayed at the end of the menu
options. To abort settings, close the probe. Press the
MENU button to cycle through the following settings:
Temperature Display Units, °F to °C
Press the MENU button until ‘C or F’ is displayed. Press SET to toggle between
‘°F’ and ‘°C’ as displayed in the upper right hand corner of the display. When the
selection is complete, press MENU to store setting.
Display Resolution, 1° to 1.0°
Press the MENU button until the current resolution setting ‘0.1°’ or ‘1°’ is
displayed. Press SET to toggle between ‘0.1°’ and ‘1°’. When the selection is
complete, press MENU to store setting.
Screen Rotation
Press the MENU button until ‘DISPLAY’ is shown at the top of the display. Press
SET to select ‘360°’ for full 4-way rotation, ‘180°’ for 2-way rotation (horizontal
only), or choose to lock the display in a specific orientation when ‘Loc’ is
displayed. Press MENU to store the rotation setting.
Auto-Off/Sleep Mode
Press the MENU button until ‘SLEEP’ is shown at the top of the display. Press the
SET button to step through the sleep interval settings from ‘10’ seconds to ‘180’
seconds in 10-second intervals, or to turn the sleep function ‘off.’ Press MENU to
store the sleep interval and the instrument will enter sleep mode at the specified
number of seconds without movement detected. END will flash momentarily to
show that all settings are saved.
Note: When the probe is open and the instrument is in sleep mode, any motion
detected by the Thermapen will conveniently wake the instrument and turn it back
on.
When you are done adjusting settings, replace the battery cover and tighten the
battery cover screw with a Philips screwdriver. Do not overtighten.
Intelligent Backlight
When the Thermapen ONE is turned on, a light sensor (small
round window located just to the right of the main display)
continuously monitors ambient light levels. As it gets darker, the
intelligent backlight comes on automatically to read the digits in
any light condition. Covering the light sensor will also turn on the
backlight except in well-lit areas. The backlight will remain on for
a minimum of 10 seconds. If the instrument is displaying the
low battery symbol, the backlight brightness will be reduced to
prolong battery life.
S
M
AAA
MENU
SET
Light Sensor
