Thermaltake VI5000BNS, Руководство пользователя

Страница: 11 / 16

Each motherboard has different standoff layout. It is highly
suggested that you refer to your motherboard's manual when
installing motherboard into the Case. The cases are applicable with
Micro ATX motherboards.
Your motherboard may require a special I/O Panel, which should be
included with your motherboard.
Placement Direction:
When installing the motherboard, make sure you follow the direction
provided by your motherboard manufacturer. On most standard
motherboards, the edge with external ports goes to the rear part of the
chassis. It is highly recommended that you install CPU, heat sink and
modular components before fixing the motherboard inside the chassis.
3.1 Motherboard Installation
Chapter3 Motherboard & Leads Installation Chapter3 Motherboard & Leads Installation
3.2 Case LED connections
On the front of the case, you can find some LEDs and
switch leads (POWER SW*1, POWER LED*1, H.D.D.
LED*1, RESET SW*1).
Please consult user manual of your motherboard
manufacturer, then connect these leads to the panel
header on the motherboard. These leads are usually
labeled; if not, please trace them back to the case
front to find out their source.
-
POWER LED
connects to your M/B at the PLED
-
POWER SW
connects to the PWR connector on the motherboard.
-
H.D.D LED
connects to the 2-pin labeled HDD LED connector.
-
RESET SW
connects to the RSW connector on the motherboard,
9
8
The locations of the
screw holes. Note
these locations and
place included
standoffs on the
chassis first.
This side towards
the rear of the
chassis
Above illustration is a sample of what
the motherboard's layout. For more
detail screw hole placement, please
refer to your motherboard manual.