950-0265revC - 9 - November 30, 2020
Installation (CONT’D).
Indoor unit is now installed. It should be plumb, level and flush with the wall. Insure that the line set stubs are
completely through the wall penetration. Also check that the wall is
plumb. The unit must be level and plumb for proper condensate
removal.
Check the drain hose, observe that the condensate drain pipe does
not curve upward and is in the lower part of the pipe bundle.
NOTES:
1) Two carbon filters are included with unit. These can be installed in the center of the filters supplied.
2) After the indoor unit is mounted and snapped to bracket, it can be adjusted slightly left and right without
removing from wall.
Step 7
Outdoor Installation
Locate outdoor unit. Clearances for the outdoor unit are:
Do not install the outdoor unit in a location exposed to high winds (field fabricated and installed wind baffle may
be required). Ensure location does not impede access around unit and pose a disturbance to neighboring
areas.
Step 8
Install drain joint
Heat pump units require a drain joint. Before bolting the outdoor unit in place,
you must install the drain joint at the bottom of the unit. Note that there are two
different types of drain joints depending on the type of outdoor unit.
● If the drain joint comes with a rubber seal (see Fig. A), do the following:
1. Fit the rubber seal on the end of the drain joint that will connect to the outdoor
unit.
2. Insert the drain joint into the hole in the base pan of the unit.
3. Rotate the drain joint 90° until it clicks in place facing the front of the unit.
4. Connect a drain hose extension (not included) to the drain joint to redirect
water from the unit during heating mode.
● If the drain joint doesn’t come with a rubber seal (see Fig. B), do the following:
1. Insert the drain joint into the hole in the base pan of the unit. The drain joint will click
in place.
2. Connect a drain hose extension (not included) to the drain joint to redirect water
from the unit during heating mode.
The 1/2" I.D. tubing can be connected to the fitting directing the water away from the unit. Check to be sure the
drain water is free to exit.
Note:
