Thermal Dynamics CE CutMaster 80XL, Руководство по эксплуатации

Страница: 15 / 46

Manual 0-2724 2-1 INTRODUCTION
SECTION 2:
INTRODUCTION
2.01 Scope of Manual
This manual contains descriptions, operating instructions
and basic maintenance procedures for the CutMaster
80XL Plasma Cutting Power Supply. Service of this equip-
ment is restricted to Thermal Dynamics trained person-
nel; unqualified personnel are strictly cautioned against
attempting repairs or adjustments not covered in this
manual, at the risk of voiding the Warranty.
Read this manual thoroughly. A complete understand-
ing of the characteristics and capabilities of this equip-
ment will assure the dependable operation for which it
was designed.
2.02 General Description
The power supply provides 60 amp maximum output and
includes all control circuitry, electrical and gas inputs and
outputs, pilot circuitry, torch leads receptacle and a work
cable with clamp.
The power supply can be ordered in various configura-
tions with various options factory installed. Refer to Sec-
tion 2.04 for a list of power supply options and accesso-
ries.
A-02837
Power Supply
Torch and
Leads
Work Cable
With Clamp
Figure 2-1 CutMaster 80XL Power Supply
The power supply is designed to work with the Model
PCH/M-102 Plasma Torches. The torch includes a spare
parts kit which provides an assortment of replacement
torch parts.
2.03 Specifications/Design Features
A. Power Supply Technical Specifications
The following specifications apply to the Power Supply
only:
1. Front Panel Controls
ON/OFF Switch, RUN/SET Switch and Output Cur-
rent Control
2. Front Panel LED Indicators
AC, TEMP, GAS, DC
3. Rear Panel
Input power cable with strain relief, gas connection
and Gas Regulator/Filter Assembly
4. Input Power
Available for the following input power:
208/230 VAC (±10%), 50/60 Hz, Three-Phase
380-415 VAC (±10%), 50/60 Hz, Three-Phase
460 VAC (±10%), 50/60 Hz, Three-Phase
Supplied with 4-conductor Input Power Cable with
filtering beads.
5. Output Power
Continuously variable from 15 to 60 Amps maximum
6. Duty Cycle (see NOTE)
NOTE
The duty cycle will be reduced if the primary in-
put voltage (AC) is low or the DC voltage is higher
than shown in the chart.
Ambient
Temperature
104° F
(40° C)
104° F
(40° C)
104° F
(40° C)
Duty Cycle
45% 60% 100%
Current
60 Amps n/a n/a
DC Voltage
120 vdc n/a n/a
CutMaster 80XL Duty Cycle
7. Cut Capacity
7/8 inch (22.2 mm); 1-1/4 inch (31.8 mm) severance
8. Pilot Circuitry
Capacitive Discharge (CD), Pulsed DC