Thermal Dynamics CE CutMaster 100, Руководство по эксплуатации

Страница: 28 / 48

OPERATION 4-4 Manual 0-2844
6. Protect eyes and press or activate torch switch.
a. Gas pre-flow starts (approximately 2 seconds).
b. GAS Indicator turns ON.
7. After gas pre-flow:
a. Power Supply enabled.
b. DC indicator turns ON.
c. Pilot Relay closes.
8. Pilot arc is established.
9. Move Torch within transfer distance of workpiece.
a. Main arc transfer.
b. Pilot arc OFF.
10. Complete cutting operation.
NOTE
If the torch is lifted from the workpiece while the
torch switch is activated, the main arc will stop
and the pilot arc will automatically restart.
11. Deactivate the torch.
a. Main arc stops.
b. Pilot arc stops (power supply enable signal re-
moved).
If torch is activated during post-flow, the pilot
arc will immediately restart. If torch is within
1/4 inch (6.4 mm) transfer distance to
workpiece, the main arc will transfer.
12. Gas will flow for 10 seconds (post-flow).
a. Gas solenoid closes.
b. Gas flow stops.
c. GAS indicator turns OFF.
13. Place the ON/OFF power switch on the front panel
of the unit to OFF (down) position.
a. AC Power indicator turns OFF.
b. Fan turns OFF.
14. Place the main power disconnect to open.
a. Main AC power is removed from the system.
For information on cutting techniques, cutting
problems, cutting speeds, cut quality, etc., re-
fer to the torch manual supplied with the torch.