SPOOL HUB ASSEMBLY INSTRUCTIONS
0-5223 1 December 22, 2011
© 2011 by Thermadyne Industries
Spool Hub Assembly Installation
The following components are included in this kit.
Item
Description
Qty
1
Fibre Washer
1
2
Spool Hub
1
3
Flat Washer Large Hole
1
4
Keyed Washer
1
5
Spring
1
6
Flat Washer Small Hole
1
7
Trib-lobe Nut
1
8
Retaining Clip
1
Art # A-10929
7
5
8
Axle
6
1
2
4
3
1. Install parts numbered 1 to 6 over the axle in the sequence shown above. Align the flat edge of the Fibre
Washer with the flat edge of the recess in the Spool Hub.
2. Install the Tri-lobe Nut (7) into the Axle through parts numbered 6, 5, 4 and 3.
3. Insert the Retaining Clip (8) into one of the set holes on the Spool Hub (2).
NOTE
Normally, the Spool Hub Assembly has been installed to the power source as delivered from the fac-
tory. These installation procedures are designed for future replacement.
Thermadyne Holdings Corporation
Suite 300, 16052 Swingley Ridge Road
St. Louis, MO 63017, USA
Telephone: 1-800-426-1888 • Fax: 1-800-535-0557
Email: [email protected]
www.thermalarc.com
Manual 0-5223
Spool Hub Assembly for
Fabricator 211i & 252i
Transmig 200i & 250i
Part Number: W7005311
Assembly Instructions
