Page 3
6.
Tape all duct connections to assure an air tight system.
7.
Place chrome reflectors into position and secure with chrome flat head countersunk
screw (provided).
8 .
VCK300 ONLY
- Install VCK300 power unit (packed separately) as shown
in figure 5. If VCK300 is installed with the VCK1 the plug or cap is to be
removed from the receptacle and discarded.
(Plug motor lead plug into nylon receptacle adjacent to the ceramic lamp socket at
the left end.) Be sure flange at the outlet end of the blower is slipped under
retainer angle to assure proper location. Tighten wing nuts after mounting bolts
are installed correctly, see figure 5.
IMPORTANT:
Spin blower wheels to assure they will spin.
9 .
Place filter with holes over the 2 threaded studs so the name plate is
facing outward at the right end of the filter front. Secure with
decorative thumb screws, but do not over tighten.
➛
➛
➛
➛
➛
•
•
1234
1234
1234
12
12
12
12
12
12
12
12
12
12
12
12
12
12
12
12
12
12
12
12
12
12
•
•
➛
➛
➛
➛
3/4"
Min.
Fig. 6
TYPICAL INSTALLATIONS
VR600 & VR1000 Vertical Discharge Only
Custom wood or sheet metal hood
10" Round Duct
(Not supplied)
Transitions:
•For VR1000 -
#1308-10
•For VR600 -
#1308-8
Front
10-1/2" Absolute Minimum
Recommended Depth
4-1/4" Minimum
VCK300 Vertical or Horizontal Discharge
Custom wood or sheet metal hood
3/4" Required
for clearing
Collar for
Horizontal
Discharge
Standard Kitchen Cabinet
Damper Collar for
3-1/4" x 10" Duct
Standard Kitchen Cabinet
*For 7" round duct use transition #1255-17, finish
with #1255-6 Roof Jack or #1255-1 Wall Cap