Thermador Pro Harmony PRL364GDH/01, Руководство по обслуживанию, Страница: 65 / 68

Service Manual for the Thermador Pro Harmony Range, Model PRL364GDH/01
58300000154022_ARA_EN_D
Page 65 of 68
6.5.11 Door Hinge Removal and Replacement
Check for applicable technical documents for this appliance in
QuickFinder before replacing the Door Hinge.
When the door is removed from the range, never release locking
levers or try to close the hinges. Without the weight of the door, the
powerful springs will snap the hinges shut with great force.
1. Follow all safety precautions and steps in Preparing the Range for
Servicing , page 19.
NOTE: You may be required to replace both hinges, as well as the
oven gasket (see Door Gasket Removal and Replacement,
page 61 ). Read the Technical Service Bulletin and all other
applicable documents for this appliance listed in QuickFinder.
2. Remove oven door (see Door Removal and Installation , page 60 ).
3. Gently place the door (porcelain side facing down) on a flat, stable
surface. Then remove and retain the T-20 screws on the base of
the door (see Figure 127).
Figure 127: Door (Typical Model Shown)
4. Lift and remove the stainless steel door cover (see Figure 128).
Figure 128: Removing the Stainless Steel Door Cover
5. Turn the door over, with porcelain side facing upward.
6. For each hinge, remove and retain the three T-20 screws that hold
the hinge onto the door (see Figure 129).
Figure 129: Screws Holding Hinge onto Door