Service Manual for the Thermador Pro Harmony Range, Model PRL364GDH/01
58300000154022_ARA_EN_D
Page 41 of 68
4. While pushing the protruding clip at the front end of the LED
indicator, push the LED indicator frontward through the hole in the
control panel (see Figure 69).
5. Replace the LED indicator if needed.
Figure 68: LED Indicator Connectors
Figure 69: LED Indicator
6.3.14
Control Board Removal and Replacement
1. Follow all safety precautions and steps in
, page
2. Follow all steps in
Accessing Components under the Maintop
NOTE:
On some models, the simmer board may be attached to
the side of the control board shield.
3. Remove and retain the T-20 screw(s) holding the control board
shield onto the range chassis and then remove the control board
shield (see Figure 70).
Figure 70: Control Board Shield
4. Remove all multi-pin connectors and individual tab connectors
from the control board (see Figure 71).
5. At the control board, detach the green ground wire from the
ground screw on the range chassis.
-OR-
Alternatively, at the control board, detach the single red blade
connector (for the green ground wire) from the control board
(see Figure 71, page 42).
Screw
Protruding clip