Service Manual for the Thermador Pro Harmony Range, Model PRL364GDH/01
58300000154022_ARA_EN_D
Page 25 of 68
9. While removing the insulation (see Figure 36), be careful not to
pull on the thermostat bulb.
Figure 36: Removing the Insulation
10. Remove the insulation support bracket by pulling its two prongs
out of the slots in the retaining plate (see Figure 37).
Figure 37: Insulation Support Bracket
6.2.5
Burner Support Rail Removal and Replacement
This procedure is for the removal of the burner support rail with the jet
holder assemblies attached, which may be necessary in order to gain
access to components for servicing. If a jet holder assembly needs to
be removed from the burner support rail or needs to be replaced, see
Jet Holder Assembly Removal and Replacement,
page
Figure 38: Burner Support Rail
1. Follow all safety precautions and steps in
, page
2. Using a 9/16 inch wrench, unscrew the hex nuts to remove the
gas tubes from the jet holder assemblies. Be careful not to bend
the gas tubes (see Figure 39).
Figure 39: Removing Gas Tube from Jet Holder Assembly