Service Manual for the Thermador Pro Harmony Range, Model PRL364GDH/01
58300000154022_ARA_EN_D
Page 66 of 68
Sharp Components
Wear gloves when removing the door hinge
Caution
The upper part of the porcelain door panel has two screws fastened
with Loctite adhesive, which should not be removed. Therefore, when
removing the hinge, open the door only as much as needed to remove
the hinge, as opening the door too much may damage the door.
7. With one hand, raise the porcelain door panel upward (to separate
it from the rest of the door) just enough to remove the hinge, while
you simultaneously remove the hinge with the other hand.
NOTE:
It may be advantageous to place a wooden block
in-between the door panels when removing the hinge.
Figure 130: Hinge
6.5.12
Thermostat Removal and Replacement
The thermostat controls the griddle temperature. Check QuickFinder
to order the correct Thermostat.
1. Follow all safety precautions and steps in the
2. First make a note how the wires are connected to the thermostat
on the back side of the control panel, and then disconnect the wire
harnesses and connectors.
NOTE:
It is always recommended to label and tag all wires and
harnesses prior to disconnecting them, so as to correctly identify
their connections/locations when reassembling.
HINT:
Alternatively, you can photograph the wire connections
prior to disconnecting (for example, with your mobile phone).
3. Using a T-20 driver, remove and retain the two screws on the
bezel of the griddle control knob (see Figure 131).
Figure 131: Screws Attached to Thermostat