Thermador Pro-Harmony P36, Руководство по установке

Страница: 17 / 44

14
Step 7: Backguard Installation
6” or 9” LOW BACK:
6” Low Back – included with 30” Pro Harmony Gas
Range.
Model GP36LB, 9” tall – for 36” Pro Harmony Gas
Ranges.
22” High POT-and-PAN SHELF:
Model GP30HS – for 30” Pro Harmony Gas Range.
Model GP36HS – for 36” Pro Harmony Gas Ranges.
3” ISLAND TRIM:
Model GP30IT – for 30” Pro Harmony Gas Range.
Model GP36IT – for 36” Pro Harmony Gas Ranges.
· The backguard must be attached before sliding the
range into the final, installed position. A Low Back
or Pot-and-Pan Shelf must be installed when there
is less than 12” clearance from a combustible back
wall and the back of the range above the cooking
surface. SEE RANGE INSTALLATION MANUAL.
· An Island Trim is available for covering the
backguard area of the range for island installations;
however, the Island Trim can only be used where
there is a minimum of 12” horizontal clearance
between a combustible back wall and the back of
the range.
· The backguard is inserted inside the guide channels
on the back of the range, as shown in the illustration.
(Remove the griddle or grill assembly for sufficient
installation clearance on griddle or grill models.)
Using a T-20 size Torx driver, fasten the backguard
WARNING
To avoid possible burn or fire hazard,
a backguard designed specifically for
this range must be installed whenever
the range is used.
with four (4) Torx-head screws to the range side
panels, and eight (8) screws to the bottom flange
and area around the cooling fan. See the (12)
locations identified (by arrows) in the illustration.
IMPORTANT: All 12 screw locations must be
used for proper air movement behind the
backguard.
· The Pot-and-Pan Shelf models require pre-
assembly of the top panel to the shell using nine (9)
of the enclosed Torx-head screws. For sufficient
load strength, YOU MUST attach the two (2) Torx-
head screws through the back corners of the top
down into the shelf.
· To secure the front of the back guard, install three
(3) of the Torx head screws through the lower front
panel of the backguard, into the flange at the back
of the range’s cooktop.
· The Pot-and-Pan Shelf models provide a shelf
above the cooktop to keep foods hot or store
cooking pans. OBSERVE CAUTIONS BELOW
LEFT.
Chart C: Backguard Kit Model Numbers
Range Width 6" Std. Low Back 9" Low Back 22" Pot and Pan Shelf 3" Island Trim
30" Included with Range N/A GP30HS GP30IT
36" N/A GP36LB GP36HS GP36IT
CAUTION
The Pot and Pan Shelf can get very hot!
DO NOT place the following items on top of
the Pot and Pan Shelf:
- plastics or containers that can melt
- flammable items
- a total load over 30 pounds (13.6kg)
The back panel of backguard is positioned inside
these two guide channels on the back of the range.
Front of Range
FIG. 8
®
®