Thermador PRL304EG, Руководство по обслуживанию

Страница: 59 / 118

Service Manual for Thermador Pro Grand LP Gas Ranges, Models: PRL304EG, PRL364EDG, PRL364ELG, PRL366EG, PRL484ECG, PRL486EDG, PRL486EDPG, PRL484ELG
58300000156573_ARA_EN_B
Page 60 of 119
m
Caution
Fragile Components
Be careful not to exert too much pressure on the standoffs or the
control board, as these are fragile components.
6. Using a needle nose pliers, disengage the control board from all
the plastic standoffs by lightly pressing the tiny protruding clip on
each standoff, while simultaneously pulling the control board off
the standoff.
7. Replace the control board only if needed.
Figure 111: Control Boards and Shield
1 Control board for main (large) oven
2 Control board shield with fault code instructions
3 Control board for auxiliary (small) oven
4.5.17.2 Control Board Removal and Replacement – Small Oven
This procedure is for the oven control boards of the small ovens on
the 48-inch ranges. For replacing the control boards on the large
ovens of 48-inch ranges or the ovens of 30-inch and 36-inch ranges,
see
Control Board Removal and Replacement – Main Oven, page 59.
Be sure to check QuickFinder for relevant information, documentation,
and the correct part number when replacing this component.
1. Follow all safety precautions and steps in Preparing the Range for
Servicing, page 21.
2. Follow all steps in Accessing Components under the Maintop,
page 21.
3. If obstructing access to the small oven control board, remove the
burner support rail (with jet holder assemblies attached) by
following the steps in
Removing the Burner Support Rail , page 24 .
4. Remove all wire connectors from the control board relays and
terminals (see Figure 111 and Figure 112).
NOTE: It is always recommended to label and tag all wires, wire
connectors, and harnesses prior to disconnecting them so as to
correctly identify their connections/locations when re-assembling.
Alternatively, you can photograph prior to disconnecting (for
example, with your mobile phone).
m
Caution
Fragile Components
Be careful not to exert too much pressure on the standoffs or the
control board, as these are fragile components.
5. Using a needle nose pliers, disengage the control board from all
the plastic standoffs by lightly pressing the tiny protruding clip on
each standoff, while simultaneously pulling the control board off
the standoff.
6. Replace the small oven control board only if needed.