Thermador CJ302B, Руководство по обслуживанию

Страница: 30 / 121

CJ Oven Service Manual Lit. No. 94-30-007A
Page 29
REMOVING A HALOGEN LIGHT ASSEMBLY
WARNING
CAUTION
Turn off the electrical power going to the
oven before servicing.
When you work on the oven, be careful
when handling the sheet metal parts. There
are sharp edges present and you can cut
yourself if you are not careful.
1. Turn off the electrical power going to the
oven.
2. To make servicing inside the oven easier,
remove the microwave oven door (see
Page 37 for the procedure).
3. Remove the oven racks.
4. Remove the screws from the rack support
that is over the halogen light you wish to
service.
CAUTION: When you remove the halogen
lens holder and lens in the next step, be care-
ful that the lens does not fall out and break.
5.
Remove the four screws from the halogen
lens holder and remove the holder and
lens from the oven liner.
6. Remove the screws from the metal screen
that is over the halogen light and remove
the screen.
7. Pull the light assembly out of the oven
liner cutout and remove the halogen bulb
from the socket.
Lens Holder
& Lens
8. Cut the leads that are coming from the
light socket near the socket body.
9. Cut the leads of the new light assembly
approximately 3˝ from the body.
10. Remove 3/8˝ of insulation from the cut
lead ends and the wiring harness.
11. Twist two small wire nuts over the ends
of the leads.
Light
Assembly
Halogen Bulb
Cut Leads Here
Metal
Screen
Screw
(1 of 20)
Screw
(1 of 4)