14
WARNING: FIRE HAZARD - loose or
improper electrical connections can cause
fire. Make certain that all electrical
connections are properly made.
• Do not pre-twist the wires before connecting
them with wire nuts.
• Extend the dishwasher’s stranded wires 1/8”
(3mm) beyond the power supply cable’s solid
wires, as shown in Figure 26.
5. Using the supplied wire nuts, connect the electri-
cal supply wires to the dishwasher’s wires, black
to black, white to white, and green or bare to
green or bare. Make certain that the insulated
wires show no bare wire from the bottoms of the
wire nuts. Gently tug the wires to make certain
they are securely connected.
6. Press the wires into the junction box. Make certain
that the wire nuts do not loosen.
7. Place the cover on the junction box and secure it
to the junction box with the supplied screw.
Figure 26
ELECTRICAL CONNECTION (continued)
Figure 27
Figure 28
1/8”
3mm
BASE AND TOE PANEL
Regular Toe Panel Installation
Use the toe panel screws (Figure 1, letter D) from
the Dishwasher Installation Kit and a Torx screw-
driver to install the toe panel as shown in Figure 28.
(Continued on next page)
DOOR TENSION
ADJUSTMENT (only on
DWHD94BF)
After the dishwasher is installed, open and close the
door several times to make sure that it does so with
ease. If the door closes too quickly or if the door falls
open, the spring tension needs to be adjusted.
To Adjust the Spring Tension:
1. Obtain the provided Door Tension Screws (Figure
1, letter K) from the DWHD94BF parts bag.
2. Insert the screws as shown in Figure 27. Turning
the screw clockwise increases the spring tension.
Turning the screws counter-clockwise decreases
the spring tension.
