THERMACUT EX-TRAFIRE 40SD, Руководство оператора

Страница: 18 / 72

EX-TRAFIRE
®
40SD
Operator Manual, Revision T-15 3-18
Power supply location
Place the plasma arc power supply EX-TRAFIRE
®
40SD on a flat even surface with a minimum
distance of 0�5m of clear space all round to ensure good ventilation�
Mains power connection
The EX-TRAFIRE
®
40SD plasma arc power supply requires a 100 - 130 VAC (CE) – 220 -240 VAC
(CE/C-TICK) single-phase mains power source� Use a circuit breaker for power line input so that
the operator can turn off the power supply quickly in an emergency� Locate the switch so that it is
easily accessible to the operator� The interrupt level of the switch must be equal to or exceed the
continuous rating of the fuses� Use slow blow fuses with a suitable capacity in accordance with local
and national electrical codes�
Connecting to an engine drive power generator
When using an engine drive generator to power the EX-TRAFIRE
®
40SD:
•
Engine drive operation;
1� Set engine drive output to single-phase AC�
2� Plug the EX-TRAFIRE
®
40SD mains power lead in to the power outlet�
3� Hard wire connection (No plug fitted) should be performed by a certified electrician�
4� Set the engine drive to maximum output (see chart below)�
5� For optimum performance, do not share the engine drive with other equipment such as
welding plant, lighting systems or angle grinders�
Single-phase, 50/60 Hz
Input voltage Engine drive rating Current output
EX-TRAFIRE
®
40SD
Performance
100 - 130 VAC 3�45 kW 30 A full arc stretch
220 - 240 VAC 5�98 kW 40 A full arc stretch
Grounding
To reduce electromagnetic interference (EMI) and to ensure personal safety and correct operation,
the EX-TRAFIRE
®
40SD must be properly grounded through the mains power lead in accordance with
local and national electrical codes of practice� The single-phase service must be of the 3-wire type
with a protective green-yellow wire for protective earth ground and must comply with national and
local electrical codes of practice�