Page 3 of 4
(05/26/10)
Medium (100°F) - two blinks
High (111°F)
- three blinks
6.
Insert the Insoles into shoes or boots.
7.
Use the Remote Control unit to operate the Insoles while shoes or boots are on feet.
TO TURN OFF THE INSOLES
Turn the ON/OFF Switch at the heel of the Insoles to the left position (“OFF”).
Remote Control unit will turn off automatically when Insoles are turned off.
THE INTERGRATED LITHIUM-ION POLYMER BATTERIES
The high-quality Lithium-Ion Polymer batteries (no memory effect) can be re-charged
approximately 500 times.
The batteries are embedded in the Insole material and cannot be accessed.
For best performance it is recommended to occasionally drain the batteries of both
Insoles completely before re-charging. To do this, turn the insoles ON using the
ON/OFF Switch at the heel of the insole, use the Remote Control unit to put the insoles
on the high setting (LED on Remote Control unit blinks 3 times), and then run the
Insoles until the LED lights on the Insoles turn OFF
The batteries will reach their maximum power after having been
drained and re-charged several times.
Do not fully charge the batteries if the Insoles will not be used for a long period of
time. Charge the Insoles for 20 minutes only and then again for 20 minutes after 3
months of storage. Charge completely before using the Insoles again.
If the battery in the Remote Control unit is running low, the Low-Battery Alert will start
flashing in sequence from Standby – Medium – High, etc. In this case, follow the
instructions below on how to replace the battery in the Remote Control unit.
REMOTE CONTROL BATTERY REPLACEMENT
The Remote Control unit comes equipped with one Lithium Cell # CR2032. To replace the
battery:
1.
Remove the two small Phillips screws on the underside of the Remote Control unit.
2.
Lay both sides of the Remote Control unit open on a table and dislodge the battery
from the appropriate side.
3.
Replace the battery, making certain that the positive (“+”) side of the battery is face
up.
4.
Place the two sides of the Remote Control unit together and secure with the two
small Phillips screws.
GENERAL COMMENTS TO ASSIST IN ENJOYING THE USE OF THE HEATED INSOLES
If needed, remove any existing insoles from shoes or boots to assist in making a
perfect fit for the ThermaCELL Heated Insoles.
The tabs at the end of the ThermaCELL Heated Insoles will assist in easy removal of the
Insoles from shoes or boots after use.
