Thermablaster GLDF24M-V, Руководство пользователя

Страница: 4 / 30

3
which the strong wind would shut down the
appliance.
4. This heater needs fresh air ventilation to run
properly. This heater has an Oxygen Depletion
Sensing (ODS) safety shutoff system. The ODS
shuts down the heater if not enough fresh air is
available. See Air for Combustion and Ventilation,
page 7. If heater keeps shutting off, see
troubleshooting.
5. Keep all air openings in front and bottom of
heater clear and free of debris. This will ensure
enough air for proper combustion.
6. If heater shuts off, do not relight until you have
provided fresh air from outside. If heater keeps
shutting off, have it serviced.
7. Do not run heater where flammable liquids or
vapors are used or stored under dusty
conditions.
8. Before using furniture polish, wax, carpet
cleaner, or similar products, turn heater off. If
heated, the vapors from these products may
create a white powder residue within burner box
or on adjacent walls or furniture.
9. Never set control knob between locked
positions, otherwise poor combustion and higher
levels of carbon monoxide may be resulted.
10. “Do not use this room heater if any part has
been under water. Immediately call a qualified
service technician to inspect the room heater and
to replace any part of the control system and any
gas control which has been under water.”
11. Turn off and let heater cool down before
servicing. Only a qualified service person should
service and repair heater.
12. Periodic visual check of pilot and burner
flame, with pictorial sketches or drawings.
13. The appliance must be isolated from the gas
supply piping system by closing its equipment
shut-off valve during any pressure testing of the
gas supply piping system at test pressures equal
to or less than 1/2 psi (3.5 kPa).
14. This appliance must be installed only in a
solid-fuel burning fireplace with a working flue
and constructed of noncombustible material.
15. Solid fuels shall not be burned in a fireplace
where a decorative appliance is installed.
16. A fireplace screen must be in place when the
appliance is operating and unless other
provisions for combustion air are provided, the
screen shall have an opening(s) for introduction
of combustion air.
17. The installation of appliances designed for
manufactured home (U.S. only) or mobile
home installation must conform with the
Standard for Mobile Housing, CAN/CSA Z240
MH,
in Canada, or with the Manufactured Home
Construction and Safety Standard, Title 24 CFR,
Part 3280
, in the United States, or when such a
standard is not applicable, Manufactured Home
Installations Standard, ANSI/NCSBCS
A225.1/NFPA 501A.
18. Logs are fragile; handle with care.
19. A damper clamp must be installed to
provide minimum permanent vent
opening to vent flue products, Refer to
installation instructions
.
Important Note:

An unvented room heater having an input
rating of more than 10,000 Btu/hr (2,931
W) shall not be installed in a bedroom or
bathroom; or

An unvented room heater having an input
rating of more than 6000 Btu/hr (1,758 W)
shall not be installed in a bathroom.