Therma-Tru Fiber-Classic, Сборка и установка

Страница: 14 / 24

HANDLE INSTALLATION
21
Refer to instructions supplied with handle set kit.
ATTACH STRIKE PLATE
22
Align slots in strike plate to pre-drilled
holes in active side jamb and fasten with
(3) #8 x 1 3/8 flat head screws.
Close door and adjust strike plate for
proper latch engagement.
Latch throw can be adjusted by the
slotted adjustment screw on the face of
mortise lock.
"
Pre-drill (4) 3/32 dia. pilot holes
through each screw hole of the strike
plate into the jamb.
Drive (4) #8 x 1 3/8 flat head screws
through the screw holes of the strike
plate into the jamb as shown.
"
"
13
INSERT PANEL BUMPER
20
Interior
Panel
Bumper
Head Jamb
Exterior
Insert panel bumper
into first channel from
interior in head jamb,
butting end of bumper
against stationary side
jamb. Seat panel
bumper flush
with head jamb.
Side Jamb
NOTE:
If needed, bumper can be cut down from its original length of 6 to 4
.
This will allow for a wider entrance.
½" "