Please read these instructions thoroughly before use. Failure to follow instructions may
result in equipment damage or failure, losses, injury or death.
DANGER:
To avoid possible electric shock:
• If the power cord has been damaged, DO NOT operate, SimplyClear™ Filter unit should be replaced.
• Prior to installation, inspect the quartz sleeve and UVC bulb to ensure there was no damage
during transportation.
• After installation, the SimplyClear™ Filter should be examined to ensure there is no water on parts not
intended to be wet.
• If the SimplyClear™ Filter shows signs of any water leakage, immediately unplug it from the
power source.
• If the SimplyClear™ Filter falls into the water, DO NOT reach for it. First unplug and then retrieve it.
• Close supervision is necessary when the unit is used by or near children.
WARNING:
To reduce the risk of electric shock:
• Connect only to a properly grounded receptacle, which is serviced by a Ground Fault Circuit
Interrupter and never remove the ground pin from the plug.
• Provide a “drip loop” for the power cord. This is a loop in the cord below the level of the receptacle
or plug that prevents water from traveling along the cord in the direction of the receptacle.
• ALWAYS unplug the SimplyClear™ Filter from power source when it is not in use, and before installing,
removing or servicing the SimplyClear™ Filter components.
• If an extension cord is necessary, a cord with a proper rating should be used. A cord may overheat
if the cord is rated for less amperes or watts than the unit rating.
• DO NOT immerse the SimplyClear™ Filter or plug in water or attempt to use a wet plug. Minimum
safety distance between unit and water is 6.5ft.
• The SimplyClear™ Filter is NOT suitable for use in swimming pools, swimming ponds, or other
situations where bodily contact is made with the water. Although the SimplyClear™ Filter is designed
for outdoor use, it should never be submerged in water.
Avoid contact with the UVC light. Light omitted can be harmful to the eyes and skin.
CAUTION:
To reduce the risk of equipment damage or failure:
• DO NOT place the SimplyClear™ Filter in direct sunshine.
• DO NOT place the SimplyClear™ Filter near flammable or other dangerous materials or objects.
• DO NOT use the SimplyClear™ Filter for fluids other than water.
• ALWAYS unplug the unit if there is no water running through it to prevent over heating.
• The SimplyClear™ Filter is NOT submersible; do not place the SimplyClear™ Filter where it might
contact or fall into the water. Partial burial of the unit is recommended.
• DO NOT operate during freezing conditions. Disconnect, drain and store the SimplyClear™ Filter in
a protected location.
• DO NOT operate the SimplyClear™ Filter with a pump larger than the maximum flow rate indicated
by the filter specifications. Operating with a pump larger than recommended can reduce the filters
effectiveness and cause damage to the filter or UVC and will NOT be covered under warranty.
The Pond Guy® is not responsible for equipment damage or failure, losses, injury or death
resulting from failure to follow safety precautions, misuse or abuse of equipment.
thepondguy.com | 866-POND-HELP (766-3435)
2
Содержание 130040
Страница 15: ...NOTES 15425 Chets Way Armada MI 48005 15 ...
