Themis RES-32XEL, Руководство по установке

Страница: 33 / 52

Installation and Operation
Installation Procedures
2-9
Themis Computer
2.1.5.1 Installation
1. Locate the slot within which a PCI card will be installed (see A , Figure 2-6 )
and remove the Phillips screw holding the blank I/O panel.
2. Remove the blank I/O panel and install the new PCI card, securing it with the
Phillips screw removed in Step 1 (see
B , Figure 2-6 ).
3. Carefully install each PCI card into the appropriate slot, repeating Step 1 and
Step 2, until all cards have been installed.
4. Replace and tighten the Phillips screw holding the I/O faceplate of each PCI
card to the RES-32XEL rear panel.
5. Attach any internal I/O cables to the installed PCI cards that may be neces-
sary.
6. Carefully fold and tuck any exposed ribbon cables into the cabinet.
7. If you have no further installations to perform, close the RES-32XEL chassis
by refastening the top cover removed in Step 1 on page 2-2
Figure 2-6.
PCI Card Installation
32-bit/33-MHz (5V) PCI Slots (2)
64-bit/100-MHz (3.3V) PCI-X Slots (2)
64-bit/133-MHz (3.3V) PCI-X Slots
Slot 1 2 3 4 5
A B