3
Time On
Lux
Time On
setting
Lux
Dusk/Dawn
setting
Levering area
L1
N
Switched
Load
OUT
230V AC 50Hz
Mains Supply
IN
L
N
Locating
springs
Locating springs fitted position
3
5. Installation
• Ensure the mains supply is switched off and the circuit supply fuses
are removed or the circuit breaker turned off.
• An isolating switch should be installed to enable the power to be switched
ON and OFF for maintenance purposes.
• Mark the position of the 65mm diameter locating hole centre, taking care
to avoid ceiling joists and other obstructions within the 65mm diameter.
• Drill a pilot hole to take the centre shaft of the hole cutter.
• Use the hole cutter to cut the required hole.
• Pass the 230V 50Hz mains supply and load cables through the hole
and prepare for termination.
• Terminate the cables into the terminal block ensuring correct polarity is observed
and that all bare conductors are sleeved (See section 6. Connection Diagram).
• When wiring is complete, fit the cable clamp wiring cover to the sensor unit
with the 2 screws provided (See diagram “E”).
• The adjustment knobs located beneath the sensor head (see diagram “C”)
are factory set to “Walk Test Mode”. Double check they are set as follows;
TIME – Fully anti-clockwise (Test mode).
DUSK – Fully clockwise.
Note: Make sure the Lux and Time controls are located at the bottom of the product.
• Fit the sensor to the wall box and secure it with the two fixing screws provided.
Side View
Top View
3m
360
More
sensitive
Less
sensitive
Up to 3m Presence Detection
Up to 10m Motion Detection
Top View
3m
360
More
sensitiv
Less
sensitive
Up to 3m Presence Detection
Up to 10m Motion Detection
More
sensitive
Less
sensitive
Time On
Lux
Time On
setting
Lu
Dusk/Daw
settin
Levering
L1
N
Switched
Load
OUT
230V AC 50H
Mains Supply
IN
L
N
Locating
springs
pulled
back
Side View
Top View
3m
360
Less
sensitiv
Up to 3m Presence Detection
Up to 10m Motion Detection
Side View
Top View
3m
360
More
sensitive
Less
sensitive
Up to 3m Presence Detection
Up to 10m Motion Detection
