Manual operation
(must be enabled via the ETS)
Support mode for starting
electronic motors
Activate support mode only with connection for electronic
motors (the parameter in the ETS of a channel must be
set to "electronic motor").
Press button
man.
.
Press and hold both channel buttons simultaneously.
For this push button
man.
for 3 s (LED man. flashes). The
support mode is active.
Terminate support mode
Press push button
man
.
Press button
man.
(LED lights up; the manual function
is on). The drives do not move over the bus.
Press channel
buttons.
Terminate manual operation
Press push button
man.
.
4. Installation
Basic module/extension module
Click base module on to the distributor rail.
Release slider
and remove cover
on the
extension module.
Click extension module on to the distributor rails.
Connect and
fix
both modules together.
Slide slider
to the left.
Put cover back on.
Lock cover with slider
again.
KNX bus module
Basic module and KNX module can be separated mechanically.
The blinds actuators can be started and operated manually
without the KNX
bus module.
Unlock KNX
bus module on the base module with slider
and remove or put on again and lock.
5. Electrical connection
L N
N
L
KNX
C2
C1
C1
C3
C4
M
M
M
M
Slider for socket
connector
JMG 4 T KNX
Slider
