Settings via thePixa Plug app
Optical presence detector thePixa P360 KNX
14
4
Settings via thePixa Plug app
If the presence detector thePixa P360 KNX is paired with thePixa Plug app, the following functions are
available:
•
Detection display (grid)
The motions (green) or presences (red) the optical presence detector is currently evaluating
are displayed. Walking persons are detected as motion, and sitting persons as presence.
Due to safety tracking, a motion may be displayed for a short time longer than it actually
exists. This delay time depends on past motions and cannot be changed.
•
Occupancy statistics
Graphical display of occupancy rate and occupancy density of the past 7 days, for each zone
individually:
Occupancy rate: zone occupancy per hour in %
Occupancy density: zone utilisation per hour in %
•
Heat map
Graphical display of the recorded motions over a defined period of time. Export as .csv file
possible.
•
Parameter
The following values are displayed or can be adjusted:
-
Actual temperature / temperature calibration
-
Actual brightness per zone / brightness adjustment per zone
-
Installation height
-
Sensitivity of sensor
-
Room definition
•
Control commands
The following functions can be activated:
-
Teach-in function
-
Activation of programming mode
-
Activation of test mode
-
Reset to factory settings
-
Update of presence detector firmware
•
Zones
Insertion and editing of up to 6 zones, which can be labelled. An exclusion zone can be
inserted in each zone, to suppress existing sources of interference.
Access to the presence detector can be protected by assigning a password.
A detailed description of the functions can be found in our operating instructions.
