PlanoSpot 360 DALI-2 S DE manual
24
The value range for the "IR group address button instance 13" instance variables is I (0x01) to
VIII (0x08) and All (0xFF), see also section 7.1.1 Parameters.
9.4
Start-up behaviour
When the PlanoSpot 360 DALI-2 S is connected to a power supply or if it is restarted, it goes
into the start-up phase for a defined period of time before switching to normal operation. This is
indicated by the LED flashing.
After the power supply is switched on (restoration of the bus supply), a motion sensor element
may provide signals as a result of physical properties until the PIR has stabilised. It is therefore
not possible to determine whether signals occurring immediately after start-up indicate genuine
presence or are merely transient electrical responses.
The PlanoSpot 360 DALI-2 S suppresses the signals from the motion sensor element during the
start-up phase (30 s). After 30 s (end of the start-up phase), the PlanoSpot 360 DALI-2 S sends
the current events in line with the current settings.
To ensure that anyone present is not left standing in the dark for 30 s after a bus failure, the
higher-level controller should always switch on the light when the bus supply is restored.
In accordance with IEC 62386-103, the PlanoSpot 360 DALI-2 S can send a telegram with the
information "Power Notification" following start-up if necessary. This telegram will contain
information about a bus failure or restart of the PlanoSpot 360 DALI-2 S. The higher-level
controller can then decide whether or not to switch on the light following restoration of the bus
supply.
9.5
Addressing
The addressing of the PlanoSpot 360 DALI-2 S (assignment of short addresses) is carried out on
the basis of the algorithm defined in IEC 62386-102, Annex A1 (informative). The 24-bit
commands do not overlap with the 64 devices in the 16-bit address space.
9.6
Presence
The PlanoSpot 360 DALI-2 S has two instances with regard to room occupancy and motion
detection:
-
Instance 0 provides information about the standard detection zone
-
Instance 1 provides information about the reduced detection zone
on the DALI bus in accordance with IEC 62386 Part 303.
9.7
Brightness
The PlanoSpot 360 DALI-2 S has four instances for brightness measurement:
-
Instance 2 provides integral brightness values
-
Instance 3 provides interior brightness values
-
Instance 4 provides middle brightness values
-
Instance 5 provides window brightness values
on the DALI bus in accordance with IEC 62386 Part 304.
The integral brightness value is the average of the interior, middle and window brightness
measurements.
