P.4
4
Please dry fit wing joiner into left and right wing to make sure they fit with the proper dihedral angle,
mark the wing joiner if necessary. Apply epoxy glue to both sides of all surfaces in contact. Use a
stick to apply the glueto inner side of wing joiner sleeve, and apply the glue to wing joiner before
putting them together. Wing joiner not glued properly will lead to wing failure and plane crash.
Completed
Main Wing
6
Lead to retract servo
Lead to Aileron Servo
Select the servo horn that will give
17mm travel when rotates through 90
o
.
Please refer to attched sheet for linkage connector installation.
To
L-side
To
R-side
Wheels up Position
Retract Servo
To
L-side
To
R-side
Wheels Down Position
5
Servo Set
Throttle Pushwire
3x3mm Set Screw
Washer
2mm
Washer
2mm
M2 Nut
Throttle Servo.
1.5mm
Please refer to the attached sheet for linkage connector installation.
3x3mm
Set Screw
M2
Nut
Linkage
Connector
2
2
2
4
2mm
Washer
Plywood
Plywood
E310PO28751302
