The Wings Maker Handyman EP, Инструкция по эксплуатации

Страница: 7 / 12

Outrunner Motor 28/ 30
KM0283010
Propeller Adaptor
(d3xD5) HW2340100
Rudder Pushrod
Outrunner Motor / Spinner
7
8
P.6
PB2x18 mm Screw
2
Ø1mm pilot holes for The Wings Maker horn are pre-drilled.
Please look for pin-hole marks at under side of control
surfaces.
PA2.6x8mm Screw
2
PM3x6mm Screw
4
PM2x12mm Screw
2
d3xD7mm Washer
4
Don’t over-tighten the PM2 screws, let the propeller
blades align themselves when spinning.
3
PM2x12mm
PM2x12mm
Make sure rotating motor casing is not in
contact with wirings or anything.
Optional Parts
TWM PL8210010
CLEVIS WRENCH
Please do not overtighten PB2x18mm screw. Once the screw brings the horn and backplate in
contact with the foam, add 1/2 turn will do. Overtightening will damage the foam.
√ ×
2
d3xD7mm Washer
PM3x6mm
Don't over-tighten the PM3 screws, too much
stress on the screws could split the fir e wall.
1
Brushless ESC
EZ Connector
Solder
Solder
TWM
KP0011310
ESC Ducted Fan
Straper
Fuel Tube
d2xD4x4mm
PB2x18mm
Clevis
Horn
Pushrod
Ø 1.4x125mm
Rudder Servo
4 5
M5 Nut
Ø45mm
PA2.6x8mm
TWM HW3111400
PROPELLER ADAPTOR WRENCH
Completed