Unpack & Inspect
1
You should have:
• 1 Radiator
• 1 Airvent (pre-fitted)
• 1 Blanking Plug (pre-fitted)
• 1 Diverter (pre-fitted)
• 4 Bracket Caps (D)
• 4 Bracket Screws (C)
• 4 Brackets (B)
• 4 Support Plates (A)
• 8 Wall Plugs and Screws
Contents
2
Mark and Fix Brackets
3
Diagrams of Ovali Bath
The Radiator Company prides itself on selecting products from
manufacturers who exercise tight quality control measures. We only
select models with excellent standards of welding and brazing, as well
as high quality finishes. All of our products are well packaged and
should reach you in perfect condition. Just in case however, we offer
a minimum 5-year no quibble guarantee for all
radiators and towel rails.
The Radiator Company must be notified of any
shortages or damage within 28 days of delivery.
For further information please see terms and
conditions on back page.
1. The airvent, blanking plug and
diverter are all already fitted on the
radiator.
PLEASE NOTE :
It is essential that all brackets are level to ensure a
vertical alignment for connecting the pipework.
Pipe Centres
Pipe centres left to right
Pipe centres from wall
Depth from wall
Commission
4
Please Note:
In accordance with Part L1 2006 of the Building Regulations and
BS7593:1992 code of practice for the treatment of hot water and
central heating systems, we strongly recommend flushing the heating
system post installation of new radiators and then adding the correct
quantity and type of inhibitor for use with your radiator and system
to prevent corrosion. Damage caused to systems not protected by
a suitable inhibitor will not be covered by manufacturer’s guarantee.
Width + Valves
43mm
200mm
59
52
43
2. Accurately mark bracket holes on the wall using a tape measure
and spirit level. (Height of the radiator from floor : minimum 100mm)
3. Drill 8mm diameter holes to a minimum depth of 50 mm,
and insert suitable wall plugs.
4. Place the support plates “A” on the wall in line with the wall plugs
and secure using suitable screws.
5. Insert the brackets “B” into the support plates “A”, and secure
and level with screws “C”. Fit the bracket closing cap “D” on top.
6. Hang the radiator on the first space of the brackets (please see
diagram above) and ensure the radiator is level using a spirit level.
Please refer to diagrams opposite when
following steps below:
You will need:
• Tape measure
• Electric drill and bits
• Spirit level
• Flathead screwdriver
• Crosshead screwdriver
Please Note:
The wall plugs and screws supplied will not be
suitable for all wall types. Please ensure suitable wall plugs and
screws are used.
200
43
G
A
B
C
D
