Test
Head Office
The Radiator Centre, 7 Holywell Hill, St Albans, AL1 1E
Tel: 01727 840344
Outline Electric
Fixing Instructions
1.
Before starting work, ensure working area is free of obstructions and objects that could cause harm to you or
the radiator. Unpack radiator carefully but
peel off protective plastic film (not present on all finishes)
if inspection is required then reapply until installation is complete.
If laying the radiator onto the
floor place it with the back (aluminium heat exchanger) face to the floor, unless you can ensure that there is
nothing underneath that could cause damage to the flat panel face – grit or foreign objects can scratch the
flat panel even through a protective film.
2.
Bracket fixing positions are shown on the drawing above. Accurately mark out hole positions on wall using a
spirit level and tape measure.
3.
Drill holes
for slotted bracket hole only
in wall as required by screws and wall plugs used.
4.
Attach wall mounting brackets (B) to wall initially with one screw only through slotted hole ensuring the hook
is at the top and the correctly handed bracket is used on the correct side (see drawing top view).
5.
Check brackets for alignment using spirit level, and adjust as necessary, then drill and screw second bracket
hole.
It is essential that all brackets align correctly with their corresponding mounting positions
on the radiator.
6.
Hang the radiator onto the brackets (B) ensuring both brackets are fully engaged.
Radiators are a heavy
item, and many of the radiators in our range require more than 1 person to lift them safely.
Never attempt to mount a radiator that you cannot comfortably lift.
7.
Wire radiator into a fused spur providing a means of isolation in accordance with current ISO standards.
8.
Remove any protective plastic film before subjecting radiator to heat.
9.
If installation problems arise, please refer to the Eskimo website for more detailed information. If problems
persist, please contact the Eskimo technical department – the number is shown at the top of this page.
10.
Brushed stainless steel can be cleaned with baby oil, mirror stainless steel with a mirror cleaner.
Abrasive
cleaners should never be used on Eskimo products.
