HEDGECUTTER
To adjust the angle of the Hedge cutter, depress levers A & B as shown below, to allow you to rotate
the Hedge cutter head to the desired angle & fix the locking lever to the gear ring, ensuring the teeth
are locked.
Always have a firm footing and use two hands to hold the machine
It is advisable to cut a hedge from the bottom up, sweeping the cutter head in an arc as you
move along the hedge. The double edged cutter blades allow cutting of your hedge in both
directions.
To cut the top of the hedge, adjust the cutter head to a horizontal position. Hold the cutter head
at an angle of 0-10 degrees as you sweep the head in an arc across the top of your hedge,
towards the outside to allow cuttings to fall to the ground.
Pay special attention to hedges which are positioned along wire fencing. If the cutting blades
make contact with the fence, damage may occur.
Do not use the Hedge Cutter Attachment for periods greater than 45 minutes. Take a break for
10-15 minutes or after using one tank of fuel.
If the blade comes into contact with a stone, wire or other foreign object, stop immediately and
check for any damage to the blades immediately.
Do not attempt to remove any twigs or branches jammed in the cutter blades, without first
turning the engine off.
Always check for any damage before each use and replace a damaged blade immediately, with
an approved replacement part.
Always fit the supplied blade guard when the Hedge Cutter Attachment is not in use.
