ASSEMBLY
All numbers mentioned in the below steps are listed in the parts list and diagram, located at the rear of this
instruction manual.
STEP 1
Lay down the bottom panel on a flat surface, remove the two wing nuts M6 (No.36) on the wheel axle support
to release wheel axle supports, wing nuts need to reinstall after releasing wheel axle support.
STEP 2
Turn up the wheel axle support and reinstall the wing nuts M6 (No.36). Remove the hex nuts M6 (No.3) and flat
washers Ø6 (No.2) on the bottom panel, attach the tongue support (No.1) and pay attention to the orientation
of the hole on tongue support, hole should be oriented as shown below. Reinstall flat washers Ø6 (No.2) and hex
nuts M6 (No.3), tighten all hardware when trailer is turned upright.
Pay attention to the orientation of the
hole within the tongue support (No.1)
