The Handy 20707G, Инструкции, чертежи деталей, перечень деталей

Страница: 2 / 4

POWER SUPPLY
This lift is for operation on 115 volt, 60 Hz current only. Check outlet voltage before plugging in equipment.
WARNING: This lift is equipped with a 3-prong plug which must be plugged into a grounded 115 volt, 60 Hz
power supply for your safety. Removing ground prong from plug or failure to plug into a grounded receptacle
may result in a fatal electric shock.
UNPACKING AND SET-UP
1. Remove cardboard top portion from lift. Inspect lift for any shipping damage.
2. Connect plug to 115 volt electrical source. Press up button on control pendant and raise the lift just
enough so that the detent pawl will engage the first pair of teeth it passes over.
3. Check to insure that the detent pawl is now full engaged to the mating teeth on the base. Carefully
remove the ramp stored between the lift frames. If necessary you may lift up and push the dropout
foward into its storage position to give more room for removing the ramp. The ramp can now be
placed aside until the lift is off the pallet and ready to use.
4. Locate and remove any lag screws that are holding the lift and foot guards to the pallet. It may be
necessary to raise the lift higher to do this. Be sure detent pawl is engaged to the mating teeth before
reaching into lift.
5. Set the two foot guards off to the side and then move the lift table off the pallet and onto the floor.
6. Raise the lift to a comfortable height then install the two foot guards to each side using 5/16-18 cap
screws, locking washers, and nuts. (3 places each side)
7. Install the ramp at the dropout end using the slots located in the lift base.
OPERATION-LUBRICATION
1. Loads must be centered on table at all times.
2. Loads must be firmly positioned on table at all times. Tie-down straps must be used in conjunction
with the holes provided in the lift top.
3. Allow the spring loaded detent pawl to engage teeth while raising the lift. Be sure the detent pawl stays
engaged with teeth while load is raised.
4. To lower, raise lift slightly to remove pressure on the pawl, then disengage by pulling rod into slot on
the side of frame tube.
5. All moving parts have been lubricated at the factory and should be re-lubricated occasionally to
prevent galling. Grease zerks are located at each end of frame pivot shaft.
6. The hydraulic system was filled at the factory with ATF and should not require further attention during
normal lift usage.
OTHER OPTIONS AVAILABLE
ITEM # DESCRIPTION
16588 CV-17 CYCLE VISE
– Use to sta b ilize m otorc yc les while on lift
20728
12” Sid e Extensions
NOTE: READ ENTIRE MANUAL TO COMPLY WITH ALL SAFETY AND SERVICE PRECAUTIONS.
DEATH, PERSONAL INJURY AND/OR PROPERTY DAMAGE MAY OCCUR UNLESS INSTRUCTIONS
ARE FOLLOWED CAREFULLY.