For assembly instructions, visit www.
containerstore
.com/freestanding.
www.
containerstore
.com
1.800.733.3532
© 2007 The Container Store
®
Inc. All rights reserved. Prices and product availability subject to change. 07-923 9/07
A
D
E
G
F
C
B
Step 3
(Assemble a double-sided solution)
Install Stabilization Bar
— Secure the Stabilization Bar by tapping both ends into the top
of the two Uprights with a plastic mallet.
(Figure A)
— Alternate tapping left and right ends until both are locked
into place.
— Add End Caps (included) at the top of the Uprights for a finished
appearance.
(Figure B)
If you have a 4' or longer solution, repeat above Steps 1, 2 and 3
as necessary. After all of the sections are added, place End Caps
and Center Caps (included) at the top of the Uprights for a
finished appearance. (Figure B, Figure C)
Before adding other elfa® components, adjust levelers as needed
with the wrench included with the Feet.
To attach a Ventilated
Shelf to the Feet
— Lay the Ventilated Shelf across the span between the Feet.
The support wires should run along the bottom of the shelf.
— Place the last shelf wire over the middle of each Foot.
(Figure D)
— Start at the back of the shelf. Slip the Shelf Clip over the last
shelf wire; it will snap into the notches on both sides of the Foot.
(Figure E)
— Repeat for all four corners of the Shelf.
— If your design calls for two shelves to share one Foot, begin by
attaching the clips at the joined shelves first, then clip the
opposite ends of both shelves.
To install Back Stop Bar
— Identify the top of the Back Stop Bar as shown in Figure F.
— Holding the Back Stop Bar at a slight angle, slide the top tabs
of the Back Stop Bar up into the Upright.
(Figure F)
— Press the Back Stop Bar down to lock it in place.
(Figure G)
You can now install other elfa
components as directed in
the elfa® Instructions for Easy
Installation & Assembly Guide.
