26
Installing TheCOM
Depending on the model COM you purchased the installation will be unique to your model COM
and the vehicle you are installing it in. For installation examples and ideas please see our website
@
https://utvcom.com/installation-examples/
General Install Guidelines
Connect the 12-volt power cord to a correct 12-volt power port. If you decide to hardwire the
unit it is recommended that both the hot and ground wires be connected directly to the battery
terminals to avoid interference and the cables should NOT be run together with other vehicle
wiring. The hot wire should be fused with a 10 amp in-line fuse when snipping the rear cross bar
model power receptacle. In-dash units, COMsoles, or intercom only do not require an additional
in-line fuse.
Avoid installing or running wires in proximity to pedals and other moving parts and use cable
grommets to avoid chaffing where cables pass through the bulkhead. You must fit the fuse in the
positive lead, directly after the positive terminal.
Top mounting screws allow the intercom to be mounted under a dash or to a roll bar with simple
cushion clamps (sold separately).
