background image

Important Safety
Warnings & Instructions

SAVE  THESE  INSTRUCTIONS.

This  manual

contains  important  SAFETY  WARNINGS  and
OPERATING  INSTRUCTIONS  for  the  Basement
Watchdog  Big  Dog  battery  backup  sump  pump
system.    You  will  need  to  refer  to  it  before
attempting  any  installation  or  maintenance.

ALWAYS

keep these instructions with the unit so

that they will be easily accessible.

Failure  to  read  and  follow  these  warnings  and
instructions  could  result  in  property  damage,
serious injury, or death.  It is important to read
this  manual,  even  if  you  did  not  install  the
Basement Watchdog backup sump pump system,
since  this  manual  contains  safety  information
regarding  the  use  and  maintenance  of  this
product.  

DO NOT DISCARD THIS MANUAL.

ELECTRICAL PRECAUTIONS

This installation must be in accordance with
the National Electric Code and all applicable
local codes and ordinances.

Risk of electrical and fire hazard.  May result
in death, serious injury, shock or burns.

To  help  reduce  these  risks,  observe  the
following precautions:

DO  NOT

walk  on  wet  areas  of  the  basement

until  all  power  has  been  turned  off.    If  the
main power supply is in a wet basement, call
an electrician.

NEVER

handle the control unit with wet hands

or while standing on a wet surface.

ALWAYS 

unplug  the  control  unit  and

disconnect the cables from the battery before
attempting any maintenance or cleaning.

ALWAYS

unplug  the  main  pump  when

installing  or  servicing  the  backup  pump  or
float switch to avoid electric shock.

DO NOT 

expose the control unit to water, rain

or snow.

DO NOT

pull the cord when disconnecting the

control unit.  Pull the plug.

MAKE  SURE  THERE  IS  A  PROPERLY
GROUNDED  RECEPTACLE  AVAILABLE.

This

pump is wired with a 3-prong grounded plug.
To  reduce  the  risk  of  electrical  shock,  be
certain that it is only connected to a properly
grounded 3-prong receptacle.  If you have a 2-
prong  receptacle,  have  a  licensed  electrician
replace it with a 3-prong receptacle according
to local codes and ordinances.

DO  NOT

use  an  extension  cord  unless

absolutely  necessary.    If  an  extension  cord
must be used, be sure the plug has the same
configuration as the plug on the control unit.

DO NOT

use an attachment not recommended

or sold by the manufacturer.  It may result in
a risk of fire or injury from an electrical shock.

DO  NOT

use  pump  in  pits  handling  raw

sewage,  salt  water  or  hazardous  liquids.  This
system is for ground water use only.

DO NOT

operate the computer control unit if

it has received a sharp blow, been dropped, or
otherwise damaged in any way.

DO NOT

disassemble the control unit. 

DO 

protect  the  electrical  cord  from  sharp

objects,  hot  surfaces,  oil  and  chemicals.
Avoid kinking the cord.

MAKE  SURE

the  supply  circuit  has  a  fuse  or

circuit  breaker  rated  to  handle  the  power
requirements of this system.

When  service  is  required,  contact  Glentronics
technical support at 

800-991-0466, option #3

,

or send an e-mail to 

[email protected].

Return the control unit to the manufacturer for
any repairs at the following address:

Glentronics, Inc.

645 Heathrow Drive

Lincolnshire, IL 60069-4205

BATTERY PREPARATION

Sulfuric acid can cause blindness or severe
burns.  Avoid contact with skin, eyes, or
clothing.  In the event of an accident, flush
with water and call a physician immediately.
KEEP OUT OF REACH OF CHILDREN.

To  help  reduce  these  risks,  observe  the
following precautions:

• Someone should be within range of your voice

or close enough to come to your aid when you
work near a lead-acid battery.

• Have plenty of fresh water and soap nearby in

case  battery  acid  contacts  skin  clothing  or
eyes.

• Wear  eye  and  clothing  protection  and  avoid

touching your eyes while working with battery
acid or working near the battery.

• If battery acid contacts skin or clothing, wash

immediately  with  soap  and  water.    If  acid
enters  eye,  immediately  flood  eye  with
running cold water for at least 15 minutes and
get prompt medical attention.

• Battery  posts  and  terminals  contain  lead,  lead

compounds  or  chemicals  known  to  the  State  of
California to cause cancer, birth defects or other
reproductive  harm.  Wash  hands  after  handling.
See  https://www.p65warnings.ca.gov/  for
more information.

BATTERY PRECAUTIONS

Explosive gases could cause serious injury or
death.  Cigarettes, flames or sparks could
cause battery to explode in enclosed spaces.
Charge in a well-ventilated area.  Always
shield eyes and face from battery.  Keep vent
caps tight and level.

To  help  reduce  these  risks,  observe  the
following precautions:

NEVER

smoke or allow a spark or flame in the

vicinity of the battery.

• Use  the  Basement  Watchdog  control  unit  for

charging a LEAD-ACID battery only.  

DO NOT

use  the  control  unit  for  charging  dry-cell
batteries  that  are  most  commonly  used  with
home appliances.

• Be  sure  the  area  around  the  battery  is  well-

ventilated.

• When cleaning or adding water to the battery,

first fan the top of the battery with a piece of
cardboard  (or  another  non-metallic material)
to blow away any hydrogen or oxygen gas that
may have been emitted from the battery.

DO NOT 

drop a metal tool onto the battery.  It

might  spark  or  short-circuit  the  battery  and
cause an explosion.

• Remove  personal  metal  items  such  as  rings,

bracelets, watches, etc. when working with a
lead-acid battery.  A short circuit through one
of  these  items  can  melt  it,  causing  a  severe
burn.

ALWAYS

remove  the  power  cord  from  the

electrical  outlet  before  connecting  or
disconnecting the battery cables.

• Check the polarity of the battery posts.  The

POSITIVE (+) battery post usually has a larger
diameter than the NEGATIVE (-) post.

• When  connecting  the  battery  cables,  first

connect  the  small  ring  on  the  end  of  the
WHITE  wire  to  the  NEGATIVE  (-)  post  of  the
battery,  and  then  connect  the  large  ring  on
the end of the BLACK wire to the POSITIVE (+)
post of the battery.

ALWAYS

keep the cover secured on the battery

box by slipping the tabs through the fittings
on the front and back of the box.

Do not use this system to pump flammable
or explosive fluids such as gasoline, fuel oil,
kerosene, etc. 

Page 1

!

WARNING

!

DANGER

!

WARNING / POISON

!

DANGER

POSITIVE POST HAS
LARGER DIAMETER

NEGATIVE POST HAS
SMALLER DIAMETER

POSITIVE

POST

NEGATIVE

POST

!

DANGER

Содержание big dog +





















Отзывы: