TECHNISCHER HANDEL BECKEL
LABORGERÄTE-SPEZIALGERÄTE-VERSCHLEISSTEILE-ERSATZTEILE
4
4.
Operation
-
Before use, the mixer should be placed on a solid and level base.
-
The drum should not contain any foreign objects!
-
The frame assembly must be fully located onto the drive unit.
-
The work area is to be secured from unauthorised persons.
-
Mixer only to be used for purposes described in section 2.
1. Fill only when drum is stationary
2. Plug into suitable socket,
-
onl THB EM 20 Z - set time - use safety switch
-
on THB EM FU set desired speed
-
on THB EM FUZ set desired speed and time
Actuate circuit breaker
Mixer with three-phase motor:
Observe direction of rotation - see below
Should a blocking of the mixing vessel be observed
(e.g. due to strongly compacted or setting concrete or
due to foreign body), the mixer must be switched off
i m m e d i a t e l y (potential mechanical and motor damage)
3. Mix until the required consistency is achieved.
The skimmer attachment can be used to achieve
optimal results.
4. Removal of the mixture
after turning off
the mixer:
either directly by means of shovel from the pail or
by releasing the frame assembly from the drive
and removing drum.
The frame assembly can be withdrawn after opening
of the transport lock.
Concrete mixer with three-phase motor 400 Volt
After switching the machine on, the direction of rotation of the mixing
vessel must be checked. It must rotate from right to left (arrow
indicating direction of rotation on front of mixer). If the mixing vessel is
rotating against the direction indicated by the arrow you can change
the direction of rotation by inserting a screwdriver into the slot on the
connector shroud provided for this purpose, pushing in gently and
turning clockwise or counter-clockwise (through 180°).