8
9
NOTE: For optimal results,
make sure to shake the
water and salt solution until
all the salt is dissolved.
This will make the S-Water™
more concentrated with
the cleaning, antibacterial
and deodorizing oxidants.
4. Plug in the Adapter into the eActivator, and then press the ON/OFF
button, see figure h) above. The red indicator light will turn red and
the electrolysis process will begin.
NOTE: The electrolysis process is preprogrammed to run for 10 minutes,
and it will automatically stop after 10 minutes of electrolysis.
5. Once the electrolysis process is done and 10 minutes has passed, the
indicator light will turn green, indicating the electrolysis process is
complete and the S-Water™ is ready for use.
6. Optional: To create an even more effective antibacterial version of
the S-Water™, after the electrolysis process is done, add one spoon of
white
vinegar (0.21ml) to the eActivator and shake to mix it in.
NOTE: The generated S-Water™ (with or without vinegar) will be
effective for 1-2 weeks. After two weeks, its effectiveness will be
lowered considerably.
Do not drink, heat, or mix the generated
S-Water™ with any cleaning or sanitizing products and
keep it out of reach of children.
For Floor Cleaning/Mop Use:
7. Insert the eActivator into the eActivator Holder as shown in figures
i), j) and k) below. Then, turn eActivator locking mechanism to secure
the eActivator in place, see figure k).
Figure g)
Figure h)
Indicator
Light
ON/OFF
Button
ASSEMBLY INSTRUCTIONS
1. Install the eMop Head onto the eActivator Holder, as shown in figures
a) and b) below.
2. Connect the two aluminum pipes as shown below in figures c), d),
and e).
NOTE: The buckle hole on the upper aluminum pipe should be aligned
with the buckle on the bottom aluminum pipe when connecting. Make
sure that the buckle clicks into the buckle hole for secure assembly.
USER INSTRUCTIONS
1. Fill the eActivator, shown in figure g) below, with 450ml of regular
tap/drinking water.
Do not use hot or boiling water to make
S-Water™, and do not heat or boil the finished S-Water™.
2. Add one spoon (provided with unit), which equals to 3g, of regular,
table salt.
3. Close the eActivator cover and shake it for a few seconds, until all the
salt is dissolved. Then place the eActivator on a level surface.
Figure c)
Figure a)
Figure b)
buckle
buckle hole
Figure d)
Figure e)
Figure i)
Figure j)
Figure k)
!
WARNING
!
WARNING
Содержание H2O e3
Страница 1: ...1 Instruction Manual...
