3
1
2
6 x
short
axles
1 x long axle
Tub
20-cm tube
2 x Syringes
2 x
wood sheets with
illustrations
2 x plain wood
sheets
YOU NEED ...
Cardboard
sheet
You will also need: ruler, scissors,
tap water, adhesive tape
HERE’S HOW!
1
Remove all of the rectangular parts with three
precut holes in them from the wooden sheet. Lay
four of them out in two overlapping “X” shapes
and insert the ends of the six short axles plus the
long axle into the holes in the wooden rectangles.
Make sure that the long axle and the wooden
rectangle with the hook are in the right places.
2
Now place the remaining four wooden rectangles
onto the free ends of the axles, as shown in the
picture.
3
Push both pieces of the sea monster’s head out
of the cardboard sheet and attach them to
the two wooden rectangles on the left.
4
Cut a 20-cm length of tube, connect it to a
syringe, and fill them both as described on page
9. Attach the free end of the tube to an empty
syringe. Take a connector out of the cardboard
sheet, place it beneath the thumb rest of the
empty syringe plunger, and then fold the other
side of the connector over the plunger. Join the
two sides of the connector together by fitting the
slots on the sides one over the other.
Hooks
Long axle
4
24
Giant Snapper
and the
