Getting Started with LTE Modem Cards
1 Introduction
16
mPLS62_mPLS8_mPLAS9_startup_guide_v02
2019-07-12
Confidential / Released
Page 5 of 17
1
Introduction
This document describes a ready-to-use development and test environment for the Gemalto
M2M LTE Modem Cards.
The development and test environment comprises the following hardware components
•
LTE Modem Card mPLAS9-W, mPLAS9-X, mPLS8-US, mPLS8-E or mPLS62-W
•
LTE Modem Card Adapter Board
The purpose of this document
1
is to guide you through the process of connecting the hardware,
installing the supplied drivers on a Microsoft
®
Windows 7 or Microsoft
®
Windows 8 system and
getting started with LTE Modem Card.
1.1
Supported Products
This document applies to the following Gemalto M2M LTE Modem cards:
•
Cinterion
®
mPLAS9-W
•
Cinterion
®
mPLAS9-X
•
Cinterion
®
mPLS8-US
•
Cinterion
®
mPLS8-E
•
Cinterion
®
mPLS62-W
LTE Modem Card in this document refers to all of the above mentioned product variants. Where
necessary a note is made to differentiate between these product variants.
1.2
Related Documents
[1]
PLAS9-W AT Command Set
PLAS9-X AT Command Set
PLS8-US AT Command Set
PLS8-E AT Command Set
PLS62-W AT Command Set
[2]
mPLAS9-W Hardware Interface Description
mPLAS9-X Hardware Interface Description
mPLS8-US Hardware Interface Description
mPLS8-E Hardware Interface Description
mPLS62-W Hardware Interface Description
To visit the Gemalto website you can use the following link:
1.
The document is effective only if listed in the appropriate Release Notes as part of the technical docu-
mentation delivered with your Gemalto M2M module.
