TGW CRUZbelt, Инструкция по установке, эксплуатации и обслуживанию

Страница: 37 / 94

CRUZ
®
belt IOM
P/N: E0032544 Revision Date: 03/14/2019 Page
37
of
94
Pull belt ends together and insert lacing pin.
Tension belt by rolling a football bracket away from the motor. A standard 3/8” drive ratchet will provide
correct belt tension with ease. DO NOT over tension the belt by using a “cheater bar”, “long handled
bar” or “breaker bar” on the ratchet bar or using two people with ratchets. Belt should be just tight
enough to drive the product.
To prevent possible damage to the roller bearing, when tightening the CAM (football bracket)
DO NOT use more than 15ft lbs. of torque.
Replace quick-release pins into both football brackets as shown on bed label. One football bracket may
need to be separately aligned slightly to insert the pin. Replace drive shrouds.
• Do not run the conveyor without replacing both quick release pins.
• The CAM (football bracket) must be vertical on both sides and the Cam must be aligned in the
same vertical hole position on both sides. The Cam this must not be offset from each other. (See
pictures below)
• Do not over tighten belt as this causes excessive stress on the Drive Drum Shaft and associated
bearings. DO NOT use more than 15ft lbs. of torque on the Cam (football bracket).
•
Excessive belt tension will cause premature failure of the take-up assembly.
The Cams must be vertical on each side.
CAUTION